Zanduco 71" 2-Door Ice Cream Display Chest Freezer with Flat Glass Top and 566L Capacity - 110V

The sliding door panels use LOW-E tempered glass with a champagne brown frame. Tempered glass resists thermal shock from repeated cold-to-warm contact better than standard glass. LOW-E coating reduces the rate at which heat transfers through the glass into the cold interior, meaning the freezer works less to compensate for heat gain through the lid panels.

This unit fits four baskets, each measuring 580 x 280 x 275 mm (22.8" x 11" x 10.8"). Baskets are essential for organizing novelties by category in a 16.6 cu. ft. chest. Without them, product sinks to the bottom and restocking becomes a time-consuming dig-out operation every shift, which is why the basket spec matters when evaluating a display chest freezer.

The exterior is cold-roll steel sheet with a white finish, and the interior is embossed aluminum. Cold-roll steel exterior is standard for retail chest freezers and holds up well to foot traffic and incidental contact. Wipe the exterior weekly with a damp cloth; avoid abrasive cleaners that scratch the finish and expose the steel to rust in humid store environments.

Yes, a built-in lock secures the sliding glass doors. The lock matters most in convenience store settings where the freezer sits in an unattended area after hours or where self-serve access during a shift needs to be controlled. For staffed ice cream parlor setups where an employee is always present, the lock is a secondary feature.

Condensation appears when store humidity is high and the glass surface temperature drops below the dew point of the surrounding air. The LOW-E glass coating reduces this effect by limiting heat transfer, but in high-humidity summer conditions in stores without strong air conditioning, some condensation is unavoidable and should be wiped down during opening and closing procedures.

Unplug the unit and remove all product before defrosting. Allow ice to melt naturally, never use a sharp tool or heat gun to chip it. Drain meltwater through the drain port, then wipe the embossed aluminum interior with a mild food-safe sanitizer and a soft cloth. Abrasive pads scratch the embossed surface and create sites where ice reform faster in subsequent operation.

Backed by a 1 Year Parts and Labour Warranty. This is a 1-year-only policy with no extended compressor coverage, which distinguishes it from the 5-year compressor warranty on the Juneau undercounter and showcase units in the Zanduco range. Plan your service contract accordingly.