Trento #133 Pasta Die Brass for items 16643, 13236, and 13440 Pasta Machines

This die works specifically with three Trento pasta machine SKUs: 16643 (PM-IT-0025), 13236 (PM-IT-0025-T), and 13440 (PM-IT-0040). The Trento #133 Pasta Die Brass for items 16643, 13236, and 13440 Pasta Machines is not compatible with other Trento or Omcan extruder series.

Trento dies are sized and threaded specifically for Trento-series machines, while Omcan-branded #133 dies fit Omcan-series machines. The shape number is the same, but the mounting interface differs, so they're not cross-compatible.

Yes, the listed Trento machines are designed for restaurant and small-scale production volumes. Pair this die with the right extruder from the pasta extruders lineup and confirm hourly output matches your service needs.

Mounting hardware is built into the extruder, not the die. The Trento #133 Pasta Die Brass slides into the existing locking ring or collar on your Trento machine. Confirm the original ring is in good condition before ordering a new die.

Brass holds its precision under daily pressure better than aluminum, which compresses and dulls over time. The higher upfront price translates to longer working life, more consistent pasta shape, and better resale of the machine if you upgrade.

Pause for a quick rinse every 90 to 120 minutes of continuous extrusion, or whenever you notice dough drag at the face. End-of-run deep clean is mandatory; mid-run rinses extend daily working life.

Yes, store fully dry in the original padded box or on a felt-lined die rack. Avoid stacking against other dies, since contact damage on the cut face translates directly into ruined pasta and an early replacement cost.