Zanduco Plastic Bullet Feet For Worktables

Built as adjustable replacement feet for stainless steel worktables, these bullet feet level the table on uneven kitchen floors, which keeps the work surface flat for prep work and prevents ingredients and rolling pins from sliding off. Most kitchen tile and concrete pitches toward drains, making leveling essential.

Each foot threads into the leg post and twists clockwise to lower or counterclockwise to raise, with adjustment range typically allowing leveling across slopes up to 25 mm. Use a torpedo level on the worktable surface to confirm flat in both directions before locking in.

Plastic bullet feet resist corrosion from kitchen cleaning chemicals that pit stainless feet over time, and they don't leave black scuff marks the way rubber does on light flooring. They're also dishwasher-safe if the entire table is being cleaned.

Designed to fit standard Zanduco worktable leg threading, these feet may also fit other brands using the same thread spec, though confirmation is required before ordering. Check the product listing or contact Zanduco support if you're replacing feet on a non-Zanduco table.

Wipe the feet during regular floor cleaning and check tightness monthly, since heavy worktable use can vibrate feet loose over time. Replace immediately if any foot shows cracks or stripped threading, since a failed foot tilts the table and risks dropped product.

Yes, the bullet feet are rated for the load capacity of standard Zanduco stainless worktables, including loaded undershelves and equipment on top. Avoid placing extreme point loads like cast-iron equipment legs directly above one foot, which transfers all the weight to a single point.

Absolutely, replacing worn feet on an otherwise functional worktable extends its service life cheaply. Match the replacement feet to your existing leg thread, and browse the broader worktables and shelves range if a full table replacement makes more sense, plus other commercial kitchen equipment for the line.