Zanduco Galvanized Leg Brace For Worktable 24" x 60"

This brace adds lateral rigidity to a 24-inch-depth Zanduco worktable, locking the legs against side-to-side flex during heavy prep work. It is the part to swap when an older worktable starts feeling loose at the joints.

Sized specifically for 24-inch-depth Zanduco worktables, the bolt pattern matches the support channel spacing on those models. Tables in 30-inch depth need the matching 30-inch brace, available across the commercial work tables and shelves range.

Loosen the existing leg fasteners, slide the brace into position against the channel, then bolt it through using the acorn-style nuts. Most kitchen managers complete the swap in under 15 minutes with basic hand tools.

None in normal use, since the galvanized finish protects against rust in standard kitchen humidity. Wipe down with the table during normal cleaning to clear any residue before it sets.

Don't overtighten the bolts to the point of crushing the channel, and never attempt to bend the brace to fit a non-Zanduco table. Each shortens the brace life and can void the worktable warranty.

Galvanized hardware delivers the same structural performance at a lower cost since the brace sits under the table out of sight. Stainless is overkill on hidden hardware and adds cost without daily benefit.

Replace immediately if rust has eaten through the galvanized coating or if the brace shows visible bend. For other table parts and accessories, browse the galvanized undershelves and worktable accessories on Zanduco Canada.